STL models Bowsette

3,00

STL 3d models for Super crown, Bowser horns and spikes for the perfect Bowsette cosplay. The horns have two horn attachments that you can sew to a wig, or screw to a headband, once finished. You can choose to add some magnets to keep the horns in place, it fits 12x2mm round magnets.
The spikes have threading, and you can print bolts (file included) that can directly be screwed through a hole in fabric, no glue necessary..

In stock

Description

STL 3d models for Super crown, Bowser horns and spikes for the perfect Bowsette cosplay. The horns have two horn attachments that you can sew to a wig, or screw to a headband, once finished. You can choose to add some magnets to keep the horns in place, it fits 12x2mm round magnets.
The spikes have threading, and you can print bolts (file included) that can directly be screwed through a hole in fabric, no glue necessary..

The STL files are ready to print, and are already oriented for an optimal 3d print result. The horns are 14,7cm high, and the crown is 8,7cm wide at the widest point, this should fit most 3D printers.
Use supports at a 70 degree angle, and a brim (4-6mm) for the horns. No supports for the other files necessary.

Finishing instructions:
Sand your 3D prints using 100-150 grit sandpaper, with royal use of primer or filler spray inbetween to get a smooth surface. When you’re satisfied with the results, your last layer should be a primer spray, before painting it with acrylics. Protect your paintjob with a varnish spray in satin or gloss.

 

The 3d models are made by me. These files are packed in a ZIP file, you need to extract the files correctly to be able to use them.

Disclaimer: Any rights are reserved for Nintendo. This is a fanmade item, I am not in any way an official reseller or licensed by the relevant IP owners.

Instagram